DETAILS:
Modern Lighting Get the look and feel of a high-end luxury vehicle. The VLEDS Dual Output footwell kit will provide a better driving experience by adding comfort and a feeling of safety.
New Harness Like the previous version, there is no splicing or tapping into your factory wires. The new, easier-to-install OEM-style breakout harness by Redside Electric now installed between the factory harness and the overhead panel assembly. This harness enables paralleled functionality by combining footwell and dome lights with the factory overhead light switch.
Dual Output PWM dimmer module allows for two output modes depending on the scenario.
- COURTESY MODE: Open the door, and the lights are at full output (200LM per side) and fade out with the map and dome light when the door is closed.
- NIGHT MODE: While driving at night, a soft ambient light adds a sense of spaciousness throughout the cabin. If you want it brighter, use the included screwdriver and turn it up to your liking. The output is factory set to approximately 10LM (the lowest setting).
5X Brighter The striplight bars are small but produce a considerable amount of light compared to cheap, flexible strip lights that are ten times the size. No plastic or fiberglass parts here! The circuit boards are aluminum metal core PCBs housed in a CNC'd aluminum (not cast) body and then finished with a high-quality exterior-grade black anodizing. They not only look amazing, but they will last you for years!
*Night Mode will not turn off when the factory dome light switch is in the off position.
05-15 Tacoma and 10-22+ 4Runner now available for order.
Rear add-on kits are also available. See our recommended products below.
KEY FEATURES:
| Easy Install | Plug and play OEM plug breakout harness (installs above overhead switch panel) |
| Aluminum | Beautifully CNC'd all-aluminum body striplight bar with satin black anodized finish |
| Driver | Built-in current limiting resistor and diode protects the strip from reversed polarity installation |
| Connections | Over-molded 2 pin connectors for easier installation and better reliability |
| Mounting | Super-strong 3M double-sided tape for mounting |
| Proprietary | 21x 3014 chips mounted to on an aluminum PCB that match all VLEDS LED bulbs |
SPECIFICATIONS:
| OUTPUT | 400LM TOTAL |
|---|---|
| CURRENT DRAW @ 14.4V | 0.5A |
| OPERATING VOLTAGE | 12-18V |
| LIGHT SOURCE | 3014 Proprietary Chip |
| DRIVER STYLE | Resistors |
WHAT'S INCLUDED
2x BAR_21 BAR_21 LED Bar Light
2x BAR_21 LSE VHB Tape for Smooth Surfaces
1x VLEDS High/Low PWM Dimmer
1x Dimmer LSE Mounting Tape
1x PWM Adjustment Screwdriver
1x Switched OEM-style Breakout Harness by Redside Electric
1x 4 Foot Wire Extension
8x Small Zip Ties
Always interest-free. 
